Check the
documentation
Ask the
Community
Take a look
at
Academy
Cognite
Status
Page
Contact
Cognite Support
When locating equipment on a document such as a P&ID there are often multiple references to the equipment on the drawing. When listing annotations only one of the references is highlighted (this may be a comment in the notes of the P&ID) and there is no mechanism to cycle to other references. If this could be done it would reduce the amount of time it takes to identify equipment locations .
New
Ability to cycle annotations on a document
Hi
Thank you for your request. I’ve passed it along to the Search team, and we’ll follow up as soon as there’s news.
Best regards,
Que Tran
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.