Check the
documentation
Ask the
Community
Take a look
at
Academy
Cognite
Status
Page
Contact
Cognite Support
In CDF Fundamentals class for Cognite Charts it states that one can merge the both y axis for Sunction, Discharge and Delta, but it doest state how its done. Any guidance on how to merge or make sure chart only shows one y axis?
Answer
Merging Charts Y axis
Best answer by Dariush
I guess I found it it was on the top of chart next to y-axis. Nevertheless maybe its good to mention that hint in that in the lesson
I guess I found it it was on the top of chart next to y-axis. Nevertheless maybe its good to mention that hint in that in the lesson
Hi
Hi,
I have selected Merge Units, but my Detla T is still showing on a separate axis. Suction and Discharge side tempuratures are merged though.
How do you merge everything?
I found the solution - the units for the Delta P/T series needs to be set to bar/celcius then the y axes will merge :)
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.