Hi
I have an application to read data from and I have two options either to use ODBC or OPC UA directly
What are the benchmarks or limitations when it comes to above
I have 30,000 data points to read with sample time of 1s and 5s and 10s
Best answer by Einar Omang
View originalHi,
The OPC-UA extractor is specialized for reading large amounts of data points, more so than the DB extractor. That said, this is often mostly dependent on the source system. It is likely that the OPC-UA interface for this solution just reads from the underlying database, in which case it may be much less efficient.
I can only advise that you try OPC-UA, and switch to ODBC if it is too slow.
+2
Hi
We are following up to see whether you're satisfied with the responses you've received.
If you found the responses offered by our community members to be instructive and helpful, we kindly request that you consider marking the most helpful response as the "Best Answer."
Br,
Dilini
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.
Check the
documentation
Ask the
Community
Take a look
at
Academy
Cognite
Status
Page
Contact
Cognite Support
