Could you please suggest how to limit source?
Best answer by Dilini Fernando
View originalCould you please suggest how to limit source?
Best answer by Dilini Fernando
View originalHi
I hope you are able to help solve the issue. As of now, I will close this thread. Please let us know if you have any question.
Best regards,
Dilini
Sure, you can create a RAW table in Manage staged data menu, and then you can use that table as a target in your transformation:
You can change the target afterwards or create a separate transformation that will not be scheduled for debugging purposes.
Hope that answers your question.
Could you please brief on “how one can use transformation from RAW to RAW”?
appreciate if any example shared.
It would be helpful :)
That’s a limitation of the Preview mode, it’s only meant to give you a view of the data, and then you can run the transformation. But you can use transformation from RAW to RAW, then you will not be limited by 240 seconds, and you can inspect results in the separate RAW table after the completion of the transformation job.
Here I want to run it for All…
If I run it for All its throwing an error.
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.