Skip to main content

In Charts, we have been using the “Shift Time Series” function (for creating a new Calculation time series) to assess data more effectively, but have now noticed a limitation where the calculation is limited to the data from the source time series already displayed.  If you look at the first image below (just a 10-min shift), you can see in the green calculation that there is a gap on the left where the calculation doesn’t exist due to the source data being “off the page”.  If we go to a more extreme scenario (2nd image below), now of the data shows since we are attempting a 2+ day shift in a time series.  Is there a solution where this limitation can be removed?  

For our scenario specifically, we are looking closely at (and comparing) three separate incidents that lasted about 1 minute each, but were spread out over the course of a week, so we are super zoomed in to look at the behavior signatures.  Thanks for the input!

Kind regards,

Richard

10-minute shift​​​​​

 

Multiple-day shift

 

Hi, Richard. 

Thank you for the detailes description and screenshots. This shows some of the limitations we have today on the time shift function. 

Let us have a look at what we can do on how the data is fetched and if we can make this work better for your analysis. 

Best regards, Knut Vidvei 


Reply