While doing the CDF Fundamentals, I’ve found out that if you don’t select a Data Set ID while uploading your PDF file, you later won’t be able to link it to your Asset, as your Data Set won’t be found. Also I didn’t find a way to edit this later. I had to upload a new file and select my Data Set ID. Is this expected?
What was confusing to me is the fact that the Data Set ID is marked as optional. If this is not the case, this should be flagged as mandatory in order to upload any file.
+6
Hi! I’m able to contextualize a P&ID with assets in a different data set. It says “No links” for 5 seconds and then suddenly it gives me 22 links. But you were able to contextualize?
Hi! I’m able to contextualize a P&ID with assets in a different data set. It says “No links” for 5 seconds and then suddenly it gives me 22 links. But you were able to contextualize?
Hi Sofie,
Yes, I was able to contextualize. I was trying to replicate the issue, but now I’m able to link the file to any asset even if I don’t select the data base before.
I guess this was a one time issue… Thanks for your support!
Ugh…...it failed on me until I added the optional Data Set ID as stated above. Once I did that, it was successful.
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.
Check the
documentation
Ask the
Community
Take a look
at
Academy
Cognite
Status
Page
Contact
Cognite Support